- This topic has 2 replies, 2 voices, and was last updated 6 years, 1 month ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Has anyone found a solution to the following:-
When my foxsat attempts to update it never completes.
During this time no recordings occur.
The only way to get out of this is to power off and on.
I have hummy firmware installed, are there any commands that can be used to cure the problem using that?
What is it ‘attempting to update’? Software? EPG? Something else? And from where?
It is something which occurs, usually overnight, without me requesting but.
It is annoying as I assume sheduled recording will not recorded.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.