- This topic has 10 replies, 4 voices, and was last updated 4 years, 7 months ago by
.
-
Posts
-
Can anyone help with my hdr 2000t?
It keeps switching to standby.
Sometimes it will start if i switch off at the mains.
But always switches to standby after a few seconds.
It will not respond to remote commands.
Other times it will start, butthen starts running through the channels counting down.
It has the latest software but i managed to reload it from the usb in case it was corrupted but the problem remains.
Sounds like one of the buttons on the remote is stuck.
Removed the batteries still the same.
Used another remote, as i have two,still the same.
Really odd problem.
No other suggestions folks?
mechanic – 52 mins ago »
No other suggestions folks?
Reset to factory defaults ?
Apologises for the late response.
May be worth trying the default file for your unit, this resets unit to factory condition, no guarantee it will work.
Check your Private Messages.
Thank you for the reply Barry.
But as stated in my orginal post i have already done as you suggest but the problem still persists.
mechanic – 15 mins ago »
Thank you for the reply Barry.
But as stated in my orginal post i have already done as you suggest but the problem still persists.
The file Barry has offered you is not the same as a Reset To Factory Defaults.
It returns the box to the state it was in when it was new. ie it resets pin nummber to default 0000.
mechanic – 1 hour ago »
Thank you for the reply Barry.
But as stated in my orginal post i have already done as you suggest but the problem still persists.
This is not the same as trying to upload new software, the file I have given you access to will reset the unit to factory condition i.e. you start the set up from scratch.
Apologies.I will try as suggested.
I did not get the chance to try the reset.
The unit is now working fine!
I have had it disconnected from the mains.
Can only assume it has rebooted itself.
Hope it lasts as i have loads of recorded stuff.
- You must be logged in to reply to this topic.