Small problem.

Forum › Forums › Freesat HD › FOXSAT HDR › Small problem.

Tagged: 

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 11, 2011 at 1:06 pm #12400
    Anonymous
    Inactive

    Barry can you recreate?

    Humax 1.00.15 & 1.00.17.

    Scenario as follows:

    Network set to DHCP. Box in standby, 5 minutes prior to recording start with clock being displayed in LCD.

    Power off at rear switch. Wait 30 secs. Power back on. BOOT displayed then reverts back to the clock.

    Power on via remote to active channel then Open Menu/Settings/Network. All fields zero. A change to manual restored the network.

    Repeat test with Network set to Manual and got the same result although settings fields were populated. Change to DHCP and working again.

    October 11, 2011 at 10:59 pm #28079
    Barry
    Moderator

    Will try this tomorrow, been to busy today with other stuff.

    October 20, 2011 at 9:56 am #28080
    Anonymous
    Inactive

    HI Barry – did you get anywhere with recreating this?

    October 20, 2011 at 10:33 am #28081
    Barry
    Moderator

    Hi Sorry forgot to reply.

    My units are set up manually, but changed to DHCP to check this out, and yes same result as yourself.

    October 20, 2011 at 4:15 pm #28082
    Anonymous
    Inactive

    Thanks Barry – I rather think that with manual setup the unit will display the settings but the network will not actually be up. Reboot solves.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.

The inner genius!