- This topic has 4 replies, 4 voices, and was last updated 13 years, 3 months ago by
.
-
Posts
-
My pvr 9150t showed an display of no signal when i turned it on and it would not turn to standby so i turned it off on the switch on the back. When i turned it back on the fan noise was really loud and only one green light came on the front display by the standby light.
nothing was displayed on the screen.
I believe i have the current correct software uploaded (up loaded in Dec 2011).
I have turned it off and unplugged the aerial and turned on again but only the same green light come on and no display on screen.
I have down as above and turned on with standby button pressed in but same problem.
any ideas of what to try or is it dead?
thanks
gnor20 – 2 hours ago »
any ideas of what to try or is it dead?
I don’t immediately recognise the symptoms. If the box is out of warranty, I would try opening the box and disconnecting the connections to the hard drive. If it will now boot then formatting the disk in a PC will probably resolve the problem.
Hi, I have a similar problem.
Turned my PVR9150T box on the other day. The fan makes a noise, the screen stays black and then for a fraction of a second something saying ‘BBC 1 – No Signal’ pops up and then the box turns restarts automatically and repeats the same process, over and over again. None of the buttons on the box or remote work, so I can’t even get into the menu to do a factory reset. Any ideas? Did you end up fixing your box Gnor?
Regards, Dan.
dannyboy51 – 6 hours ago »
None of the buttons on the box or remote work, so I can’t even get into the menu to do a factory reset.
Try turning the Humax off, disconnect the aerial and then start it up without the aerial. Does this allow you to do a reset to default settings?
- You must be logged in to reply to this topic.