- This topic has 2 replies, 3 voices, and was last updated 5 years, 10 months ago by
.
-
Posts
-
Hi, I have a Humax DTR -T2000 500GB model, and jujst recently I have been having problems with the remote
If I want to go back to an earlier moment of a program I’m watching, I press the reverse button ( the two reverse arrows on the remote) and watch th earlier point of the program.
However, I find while reversing, the “stop” button doesn’t work, and nether does the forward button ( the two forward arrows on the remote) and I have to press the “pause” button to stop reversing!
The rest of the remote works OK, the volume button, the program channel button, the guide and the back button, and the rest, EXCEPT the pause and forward button!
Is there a way to reset the remote control back to ” factory setting”??
Cheers
Graham
Take the batteries out for about half an hour.
However, I am more inclined to think you need to take the remote apart and clean the contacts.
SSThing – 12 mins ago »
Take the batteries out for about half an hour.
Quicker to take the batteries out and hold down a key for 10 seconds to drain any residual voltage and then replace the batteries.
- You must be logged in to reply to this topic.