- This topic has 2 replies, 3 voices, and was last updated 5 years, 9 months ago by
.
-
Posts
-
I have a Humax PVR-9150T but when I try and watch certain TV channels the picture eeps breaking up and I get the following messages.This channel is scrambled or not available and no or bad signal.I do not get these messages if I watch the TV normally.I also have a Humax HDR-1800T downstairs but do not have a problem with that one.Any advice appreciated.
blueman – 35 mins ago »
I have a Humax PVR-9150T but when I try and watch certain TV channels the picture eeps breaking up and I get the following messages.This channel is scrambled or not available and no or bad signal.I do not get these messages if I watch the TV normally.I also have a Humax HDR-1800T downstairs but do not have a problem with that one.Any advice appreciated.
First thing to check is the coax plugs are properly fixed. Belling Lee plugs need t have the centre core soldering. I always make up cabling using double screened satellite cable terminated with screw on F connectors. You can get F to belling lee male and female as needed.
blueman – 1 hour ago »
I have a Humax PVR-9150T but when I try and watch certain TV channels the picture eeps breaking up and I get the following messages.This channel is scrambled or not available and no or bad signal.
have you tried an auto retune. If that doesn’t fix the problem then try a manual retune using the instructions at https://myhumax.org/forum/topic/week-old-9300t-and-epg-wont-fill-up-for-week#post-7097
- You must be logged in to reply to this topic.