Topic: No Signal / Signal Detection Menu Greyed Out

Tagged: HDR-FOX T2, no signal, Signal Detection Menu Greyed Out

This topic has 3 replies, 2 voices, and was last updated 13 years, 1 month ago by Barry.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
October 20, 2012 at 6:48 am #13802

Anonymous
Inactive

Hi

I have started experiencing a permanent no signal issue with my HDR Fox T2 this week and would appreciate any suggestions to fix.

The box has worked ok for the last year however now at turn on from standby no signal is detected and no channels found.

There is definitely a signal as the television feeds via the Humax and this is working (when the Humax is turned on.)

I have attempted a reset to factory default, updated to 1.02.29, numerous retunes however still no signal /channels.

My only observation is that in Menu>Settings>System >Signal Detection menu option is greyed out however there is definitely a signal. Is there any settings i’m missing that might resolve or would this suggest a hardware fault?

Thanks

October 20, 2012 at 7:18 am #39109

Barry
Moderator

Welcome to the Forum

Baffled – menu items are only normally greyed out when the unit is recording, or playing back a recording.

Have you tried just switching off mains power to the unit for an hour or so?

October 20, 2012 at 7:52 am #39110

Anonymous
Inactive

Hi Barry, thanks. I turned it off last night at the mains in the hope it would come back but having tried again this morning I still have the same issue.

October 21, 2012 at 8:44 am #39111

Barry
Moderator

Completely baffled then. Strange that you could carry out a factory reset from the installation menu yet strength menu is greyed out, I would expect the install menu to have also been unavailable.

If less then a year old then back to retailer for swap out, if not contact Humax support for advice.
Author

Posts