- This topic has 4 replies, 4 voices, and was last updated 6 years, 8 months ago by
.
-
Posts
-
I purchased a NEW Humax HDR 2000T PVR last week. The initial setup proceeded without problem and the record/playback function appeared to work OK. However a couple of days later the unit does not appear to be working properly – after watching a channel (or a recording) for a short time the screen goes black and the unit appears to reboot itself (the Humax logo screen appears followed shortly after by the selected TV channel). This happens every couple of minutes and makes it impossible to use the unit. Is the unit is faulty or have I set it up incorrectly – I didn’t do anything other than what was described in the setup instructions provided.
Then take it back as faulty and see if the ‘new’ one does the same.
I don’t think there is anything in the setting up procedure that can be done that wrong that would lead to this problem. Follow Trev’s advice and return the box – it is faulty.
If you really want to give it a second chance, go through the procedure Humax would tell you to do if you contacted them – Do a full factory reset (including format hard disk).
Thanks – it will go back.
Yep welcome to the joys of the 2000. Mine will do it when coming out of the internet section sometimes.
Its a product thats never been right. I kept it for certain reasons but I should have taken it back.
Take it back and my advice is dont get the 1800 or the 2000 again. You will probably have to go for the 4000 or another manufacturer
- You must be logged in to reply to this topic.