- This topic has 2 replies, 2 voices, and was last updated 10 years, 3 months ago by
.
-
Posts
-
It’s new this year – March, maybe – and has worked ok until recently. A Freetime 1000S 1TB machine. Now, though, programmes set to record when we’ve gone to bed come up with a triangle! Record start time – record end time (which is the same) and ‘failed’.
If I don’t put the set to standby when switching off the tele, it sometimes works.
Also, a lot of low/insufficient signal messages are coming up, which are cureable by hard break – turning the power to the set off.
I have tried applying a software update, which seemed to help the record on standby when I tested it, but now it’s gone back to hopeless mode.
Any advice? Thanks for reading this far…
Sounds like a dish/lnb issue.
Tune to the channels you normally record in turn and then Settings – General Info – Signal Info
You should see the signal strength and quality for each tuner. Look at the bottom of the screen, how many cables does it say are connected ?
Yup, I guess someone yanked a cable – though I was sure I’d checked them earlier… Problem solved. Thank you.
- You must be logged in to reply to this topic.