- This topic has 5 replies, 3 voices, and was last updated 11 years, 11 months ago by
.
-
Posts
-
just bought the 2000t installed ok channel scan ok
after a week i found picture break up on the standard def channels only.
hd channels are fine.
appears to be very low signal strength i have re-tuned and manual tuned the unit as well.
is there anything else i can do is the unit faulty??
tv signal is fine at 100%
thanks.
ijy – 16 minutes ago »
just bought the 2000t installed ok channel scan ok
after a week i found picture break up on the standard def channels only.
hd channels are fine.
appears to be very low signal strength i have re-tuned and manual tuned the unit as well.
is there anything else i can do is the unit faulty??
tv signal is fine at 100%
So what are the signal strengths on the problem channels and on HD?
i think about 40%
its a new unit so still getting used to all the settings etc.
there is a strength and quality gauge not sure whats more important in the lower left when info is pressed both have 1 bar
hd channels are ok in terms of no brake-up and work ok its the sd channels which are not so good
iv’e done and auto tune without the aerial then retuned again finding all channels.
after a manual tune and playing around picture breakup has not happened tonight but its the weak signal that i am worried about.
could it be a faulty unit??
Welcome to the Forum
Whilst I appreciate you have stated that you have tried a manual tune, try reading this post re how to tune manually:
http://myhumax.org/forum/topic/week-old-9300t-and-epg-wont-fill-up-for-week#post-7097
Hello
Further investigation did a full reset and manual scan ,was scanning incorrectly for the had channels not selected dvt-2 ?? Which picked all the hd channels
All channels have %100 strength and %40 quality I thinks that’s the right way round.
Didn’t get any break up last night so I think it’s ok
Hadn’t done a manual scan before so I know what I’m doing now
Thanks for the help will monitor things over Xmas time.
Ian.
ijy – 1 hour ago »
All channels have %100 strength and %40 quality I thinks that’s the right way round.
No that is probably the wrong way round. 100% quality is almost essential for satisfactory viewing. I would regard 40% as an acceptable signal strength but without much margin of safety.
- You must be logged in to reply to this topic.