- This topic has 4 replies, 5 voices, and was last updated 4 years, 3 months ago by
.
-
Posts
-
Possibly due to being dropped the remote control for out HDR-1000S is acting rather strangely. one press of any of the buttons results is a repeat of the action over and over again so that it is impossible to access items such as settings or recordings etc. Is it possible to somehow reset or reboot the remote to see if it is a software rather than hardware problem? Any advice much appreciated
Remove batteries then press a button for a minute or so replace batteries. That should do it.
I would very much appreciate help to solve a similar problem, with the remote of my HDR 1100S, bought in August. For no apparent reason, the ‘STB’ button is constantly lit, and pressing any button makes the action repeat, so it’s unuseable. I tried pressing a button for a minute with the batteries out, but it didn’t help. I also left the batteries out overnight, to no avail. Thanks in advance.
penfro – 16 hours ago »
I would very much appreciate help to solve a similar problem, with the remote of my HDR 1100S, bought in August. For no apparent reason, the ‘STB’ button is constantly lit,
That sounds like a button is stuck down. If you can’t do anything about it then ring Humax and see if they will send you a new remote.
I have recently had the same problem where the STB remains continuously lit. To fix this problem press the 0 key and the red button (not the record button) for 5 seconds. The STB should go out and the remote should function again!
- You must be logged in to reply to this topic.