- This topic has 6 replies, 3 voices, and was last updated 4 years, 5 months ago by
.
-
Posts
-
Hello all. First time poster here. My 2nd Aura arrived today from Amazon. The 1st one had major pixelation issues. This one wont even boot up! I thought it could have been my app messing things up by looking for the 1st device I still had registered, and 1 time it did get to the android initialisation graphic and remote control setup screen, but after that it reset again. Mostly in an eternal boot loop. Humax logo and blue light then off, and back again. Any ideas? Power supply? Worth reflashing firmware (unsure exactly how to do that or where to get it – I have a USB flash drive)…any suggestions appreciated! – cheers
Thanks – great to know. So after a good hour or so powered down and without my Aura app (possibly) interfering I got a clean boot and an update to 09.14 … Now setting up and tuning in. Fingers crossed this unit is healthy
New issue – blank screen on all Live TV channels 😥
And signal Info page just exits immediately…
Success – recovery reset and this time Ts and Cs showed up. Now all good. THANK YOU @SSThing
segster – 1 week ago »
Hello all. First time poster here. My 2nd Aura arrived today from Amazon. The 1st one had major pixelation issues. This one wont even boot up! I thought it could have been my app messing things up by looking for the 1st device I still had registered, and 1 time it did get to the android initialisation graphic and remote control setup screen, but after that it reset again. Mostly in an eternal boot loop. Humax logo and blue light then off, and back again. Any ideas? Power supply? Worth reflashing firmware (unsure exactly how to do that or where to get it – I have a USB flash drive)…any suggestions appreciated! – cheers
You will need to put the new registration number into the Myhumax.net web site. Apologies if obvious.
- You must be logged in to reply to this topic.