- This topic has 13 replies, 5 voices, and was last updated 12 years, 4 months ago by
.
-
Posts
-
Have had a few little problems lately since update 1.00.54.
1.Settings not showing (missing options) happens randomly.
2.HDMI issues have to turn off box and TV takes a good few tries to get a picture. (HDMI-CEC turned off)
3.WIFI now disconnecting so have to input all the details again. When i mean disconnecting for some reason all the details are clearing itself and i have to add my password to get it to connect.
When i purchased my box it had firmware 1.00.40 note i never had one problem until i got the new update.
!. Missing options indicate option unavailable at present (Recording etc)
Not sure what you mean but say i go into system settings all options are not available or picture & sound resolution graded out so couldn’t change. Like i said these are random one minute there next minute not.
Biggest issues is the HDMI and wifi apart from these issues everything else is near perfect.
Welcome to the Forum
Not sure I have ever seen the picture/sound settings graded out.
I would start with a Factory Reset, see if that improves matters.
Will try another reset and see how it goes.
re HDMI – What brand of TV do you have?
Samsung plasma(don’t no model number as would have to take it of the wall) a few years old now but only had problems since newest firmware.
garyb – 44 minutes ago »
Samsung plasma(don’t no model number as would have to take it of the wall) a few years old now but only had problems since newest firmware.
I have seen reports that Humax may have started to support CEC in this release. I see Samsung’s name coming up more than other brands with HDMI issues. Just a thought but have you tried CEC with this software release?
For the HDMI issue make sure anything regarding Anynet+ on the TV is disabled.
Yes i have tried it with Anynet+ turned on but had even worst issues so i turned it off but still get issues but not as bad. On or off i still get issues since the updated.
I have done a reset so will test further over the next few days.
REPASSAC – 6 days ago »
garyb – 44 minutes ago »
Samsung plasma(don’t no model number as would have to take it of the wall) a few years old now but only had problems since newest firmware.
I have seen reports that Humax may have started to support CEC in this release. I see Samsung’s name coming up more than other brands with HDMI issues. Just a thought but have you tried CEC with this software release?
I have exactly the same problems as you re the hdmi link. My TV is a Toshiba.
Humax are in denial that it is their problem.
Well tested for a few days all seems good but now and then i get flickering and black screen just for a second or two not sure if this is related or a signal issue but again never had any of this until this update. This might sound funny but when i have standby mode on power save i’m back to square one cant get a signal but when i change it to normal it works fine.
Hope they are looking into this.
garyb – 22 minutes ago »
Well tested for a few days all seems good but now and then i get flickering and black screen just for a second or two not sure if this is related or a signal issue but again never had any of this until this update. This might sound funny but when i have standby mode on power save i’m back to square one cant get a signal but when i change it to normal it works fine.
Hope they are looking into this.
No logical reason why displaying the clock should make any difference at all. Are you sure?
I’m not sure of anything but that’s what works for me. Still get the faded out resolution and missing settings(randomly)until i reboot my box then its fine again. Will get a picture next time it happens.
- You must be logged in to reply to this topic.