- This topic has 64 replies, 24 voices, and was last updated 10 years ago by
.
-
Posts
-
I don’t know if anyone else has experienced this, but the last few days my 1100s has been rebooting itself every few minutes. I rang Humax support, and they said they had received several calls today about it.
They recommended resetting to Factory Defaults as a workaroud while the problem is being identified at their end. This seemed to do the trick. You don’t lose your existing recordings, but you do lose planned recordings and other personal settings. All was fine until I tried using Showcase to set a planned recording, at which point the box started crashing again.
Another reset to Factory Defaults, and this time I tried using the iPhone app to set a recording from Showcase. This caused an immediate reboot.
I’ve reported this back to Humax. Maybe it’ll help with the troubleshooting. For now, I’m just setting recordings from the programme Guide, which seems OK.
I have been having exactly the same issue with my HDR-1000S since Tuesday – frequent reboots, typically after 5-10 minutes, and problems with setting recordings.
I initially thought it was down to the hard disk being near full (92%) and used the disk cleanup utility. This seemed to help for a day or so, but the problem has returned again on Thursday and today is bad again.
Today I did a reset to factory fresh state. Seemed to work until I tried to set a recording for tonight, whereupon it immediately crashed again.
I have reported to HUmax customer support (yesterday), but have had no reply as yet.
??????
I had the same problem
first off I thought it might have been because I tripped my electric on Tuesday.
It went in to an endless loop of booting.
I tried to eliminate everything, removed ethernet,
then no satellite cables,
flashed the firmware which then allowed me to reset to factory defaults
formatted the hard drive and still no luck.
so tonight on the way home from work I bought a new 1100s, the old one was a 1000s, plugged it in at last a working box!
watched it for an hour or so then set up some of the programs I wanted to record All went fine.
Then I paired the box because I wanted to use the app, as soon as I did it, I then went to select something to record via the tv guide on the new box and guess what the rebooting started again! Exactly the same as the old box.
So I unpaired the new box via the website and it has now been working fine for the last 3 hours, I can even set recordings without a problem.
It now appears that I have wasted nearly £200 on something I didn’t need
minnie890 – 1 hour ago »
I had the same problem
first off I thought it might have been because I tripped my electric on Tuesday.
It went in to an endless loop of booting.
I tried to eliminate everything, removed ethernet,
then no satellite cables,
flashed the firmware which then allowed me to reset to factory defaults
formatted the hard drive and still no luck.
so tonight on the way home from work I bought a new 1100s, the old one was a 1000s, plugged it in at last a working box!
watched it for an hour or so then set up some of the programs I wanted to record All went fine.
Then I paired the box because I wanted to use the app, as soon as I did it, I then went to select something to record via the tv guide on the new box and guess what the rebooting started again! Exactly the same as the old box.
So I unpaired the new box via the website and it has now been working fine for the last 3 hours, I can even set recordings without a problem.
It now appears that I have wasted nearly £200 on something I didn’t need
I’m still trying to get my head around the fact you simply went out and bought a new box because your existing one was having a few hiccoughs.
Why didn’t you register on this site or a similar forum first and seek some advice. You would at the very least been able to ascertain if anyone else was having the same problems. That’s what these forums are all about.
I understand minnie890’s decision completely. I had concluded myself that my unit was failing – probably an HD problem -and that I would likely have to find the money from somewhere to replace it.
I had emailed Humax support, and while waiting for a reply stumbled across this forum after a google search. I’m immensely surprised to hear that others have been having exactly the same problem – originating at exactly the same time too. It doesn’t make sense to me how this has occurred. There have been no firmware updates since July. All the evidence before i came across this thread in the forum suggested my unit was on its way out. (Still may be, but the experience of others here is giving me some hope)
I’ve not been having the reboot problem since the last s/w update fixed that. What I have been seeing over the past two weeks is occasionally the box will spontaneously drop into the mini-guide (the one that comes up when you boot up) in the middle of watching a pgm. Never seen that before. My box is not paired with the app, which I don’t use at all.
Morning, I have a 1000/1010, which started constantly rebooting yesterday evening, whilst I was trying to set a recording via the schedule. After looking on this forum I found MikeB’s initial post and tried disk clean up and then factory reset, it was useful to know it would keep my recorded programmes. It worked ok for about 10 minutes then went into the constant rebooting, I finally turned off the power and left it off over night. I switched it on about 10/15 minutes ago, it’s been ok, but I’m sure it will start rebooting again before long. I think it may be related to setting recordings, though it did reboot whilst I was trying to watch a recording. I do not have my phone set up to programme recordings, as it’s an Android.
How do you report it to Humax?
I trawled through lots of forum posts and found no real answers, just the usual factory reset blah blah blah, but nowhere where someone had actually came up with a definitive answer.
I was on the verge of having the hard drive to test, but I am currently pushed for time as, I am working 7 days a week up to 16 hours a day, so I just want a working box.
It was only after I had got them working did I find your posts describing my problem exactly.
Both boxes are still working fine.
I must say I was very doubtful that the app was the issue, I don’t understand why as there has been no firmware updates for a while but after reading that the box spins up every 20 mind or so when paired it got me thinking.
I uninstalled my andriod app but no luck it was only when I unpaired via the website did the rebooting stop.
I am still puzzled as to why this appears to of fixed the problem.
I just hope my experience may help some people out
Torchy: To contact Humax, I phoned 0344 318 8800.
Torchy – 2 hours ago »
Morning, I have a 1000/1010, which started constantly rebooting yesterday evening, whilst I was trying to set a recording via the schedule. After looking on this forum I found MikeB’s initial post and tried disk clean up and then factory reset, it was useful to know it would keep my recorded programmes. It worked ok for about 10 minutes then went into the constant rebooting, I finally turned off the power and left it off over night. I switched it on about 10/15 minutes ago, it’s been ok, but I’m sure it will start rebooting again before long. I think it may be related to setting recordings, though it did reboot whilst I was trying to watch a recording. I do not have my phone set up to programme recordings, as it’s an Android.
How do you report it to Humax?
From my experience with my HDR1000 the issue is definitely related to recordings and setting recordings. Last night with a pending recording set I had the continual re-booting. When I cancelled the pending recording the unit worked flawlessly for hours.
I don’t use the app, so for me that is not any part of the issue.
I sent an email to Humax (UK)support at
See their Contact page for telephone details:
My 1100S has been having similar reboot problems. Started last night when I was setting up 2 single recordings … 1 of which failed. After many reboots and much cursing this morning, I read the posts on this thread and have now un-paired the box with my Android phone app. This appears to have resolved the problem (although it may be early days yet!) although it is a far from ideal solution. Have also emailed Humax support.
Hi all, another newbie here. Same reboot issues started last night when I tried to record something from the app. Hard disk started spooling every 5 minutes after switched off as well. Unplugged it overnight, this morning it wouldn’t boot up at all. Would get 30 seconds into startup then switch off! Lots of swearing followed, then I found this forum and thread. I deleted the app off my iPhone and reinstalled it which somehow allowed me to get the box to start up properly, then I did a factory reset and deleted any scheduled recordings (f1)
Box has been restarting every 15 minutes or so. I have now logged out of app and deleted it, to see if it will stop the rebooting, but it is still happening.
Hope Humax are sorting this out, otherwise there phone line is going to be busy Monday 9am.
I would agree, I have never paired it with my mobile, but the disk has been spinning up for no reason I can see for months. After leaving it powdered down over night it was stable for over an hour, but I never tried to do anything just left it on. I have also emailed their support.
Steviant
Have unpaired the box via your account on the freesat website?
that’s what finally cured my reboots
Thanks for that one Minnie. Done that now. Will see how it runs for the rest of the day.
- You must be logged in to reply to this topic.