- This topic has 18 replies, 10 voices, and was last updated 4 years, 7 months ago by
.
-
Posts
-
itm – 2 hours ago »
Any idea whether/how I might be able to get reception for these channels?
Tell us what the signal strength and quality is as reported by the Humax please (Menu Button>Settings>System>Signal detection)?
Do you have any repeats of BBC1 etc in high numbered channels above 800? You may be receiving from two transmitters, one strong (Crystal Palace) and one weak (somewhere else).
To check the signal/quality percentages if CP has not tuned at all, you will need to partially run manual tuning again and select UHF channel 23 with DVB-T and then read the values without actually trying to retune.
By the way, which Humax box are you using, it might matter and there are quite a few?
Signal Detection shows Channel 23 as 60% Strength, 40% Quality.
I do now get some reception on channels 1, 2 and 9, but with pixellation.
I don’t have any TV channels above 800 (nothing above 699).
It’s an HDR-Fox T2 with Custom Firmware.
itm – 23 mins ago »
Signal Detection shows Channel 23 as 60% Strength, 40% Quality.
The signal strength is fine; the problems are down to the low quality figure. Start by checking the aerial feed cable to the box looking for kinks or badly made joints.
- You must be logged in to reply to this topic.