- This topic has 158 replies, 41 voices, and was last updated 9 years, 10 months ago by
.
-
Posts
-
i AM USING HDMI My TV has no scart since we started using this box as it has not got a Scart connection
Welcome to our Forum
Please do not use capitals/upper case that is considered as shouting.
1. Try a different HDMI Cable
2. Check your private messages, right hand side of Forum page.
3. Please post make/model of TV.
Hi Barry – I am having the same message “HDCP is not valid, AV blocked.
I have quite an old telly a sharp aquos HDMI – please don’t tell me I have to go out buy a new telly?!!
I have same problem HDCP not valid switched tv off tv last night this problem occurred today when switched Samsung tv on any ideas please
Welcome to our Forum
1. Do you know the model number of Samsung TV
2. Check your private messages, se link on right hand side of Forum
sorry don’t no till I take tv off wall tomorrow will get back to you then
thank you
Spoke to someone at Humax about this today but said they were unaware of the issue. There must be some reason why so many of us are suddenly experiencing this. I have a Samsung tv connected to my 1000s with an HDMI cable. All worked without problem for a year until today. No tv at Christmas would be a disaster. Any resolutions gratefully received.
Richard
Jollyj30 – 49 minutes ago »
sorry don’t no till I take tv off wall tomorrow will get back to you then
thank you
Don’t go taking it off just to find model number….did you read my PM?
Welcome to our Forum Richard
Apologises for delay in response, had to take a break for a little while.
If you have model number of TV please post it.
Check your Private messages
Hi Barry,
I have the same problem
HDCP is not valid AV Blocked
System was working fine yesterday
I have Sony Bravia KDL 32EX401 and
Humax fressat+ model HDR-1000S
Thanks
Same problem as many others, ie “HDCP not valid. AV blocked” as of last evening. Sony Bravia TV. Can you help?
Same issue for me guys. Everything fine last night, came home this evening, switched everything on to see a little message informing me of helping Humax with their service improvements and boom, no picture. Got the rather helpful on screen flash stating HDCP invalid etc, and then black screen of nothingness. TV is a 5 year old Panasonic TX42, Humax is a Foxsat.
Is this really what progress is all about? At the moment the Humax is disconnected and we’ve had to resort to feeding the satellite signal directly into the TV set itself (thank god for a freesat on-board circuit)
Any clues GRATEFULLY received
- You must be logged in to reply to this topic.