- This topic has 370 replies, 98 voices, and was last updated 7 years, 4 months ago by
.
-
Posts
-
Welcome to our forums sunnysue. I’m glad you have the problem sorted, and now you can record 4 programmes and watch 2. 😆
Sadly I have only just come across this forum. I have had a Humax PVR9150 for about two years but never realised I needed to leave it n standby at night to receive automatic updates! As a result I have missed all the recent OTA updates for the model, the last being last night! I have the reported problem of the box freezing all the time. Do you know if there will be any forther OTA updates for this model in the future? My current firmware is V 1.00.18.
Thanks so much!
peanuts – 12 hours ago  »Â
Thanks so much!
And as if by magic the DTG website has been updated to reflect more repeats:
http://www.dtg.org.uk/industry/download_schedule.php
Commencing Tomorrow (Saturday), and Monday for the 9150 in your case.
Thankyou so much for your invaluable advice! Hopefullly I will get it all sorted tommorrow night if I leave the box on standby.
I would try the OTA today after 10am, will give you some time to seek advice should you encounter problems.
unfortunately I away from home this weekend so cant do that but have left box on standby. If it fails I wii try the OTA on Monday evening rather than relying on it updating overnight Monday. Hopefully if I encounter problems I will be able to come back for advice!
Just returned from my weekend away and sadly the box has not updated automatically overnight! Is the next step to try and update it while the OTA is broadcasting on Monday evening? Excuse my ignorance but is this done by running the Software Automatic Update?
You have another chance tomorrow between 10am and 9am on Tuesday. You can either leave your box on standby overnight tomorrow, and make sure your automatic updates are enabled.
Alternatively, perform a manual search for upgrades between those two times.
My 9300t was working yesterday and briefly today, but it is now completely frozen in standby mode, so I can’t even access menus to verify what update I’m on or whetehr auto updates enabled. I’ve tried powering down and removing the aerial too, nut no luck….Any ideas?
peanuts – 2 hours ago »
Just returned from my weekend away and sadly the box has not updated automatically overnight! Is the next step to try and update it while the OTA is broadcasting on Monday evening? Excuse my ignorance but is this done by running the Software Automatic Update?
These are the Humax instructions:
1) Select BBC 1
2) Press MENU
3) Select Installation and press OK
4) Enter your password (default is 0000)
5) Select software update and press OK
6) Select manual update and press OK
7) Select search and press OK
The searching will begin and you will receive a message confirming the new software version. Select Yes to confirm and press OK. The box will restart and the software will install (do not switch the box off)
redfeffer – 8 hours ago  »Â
My 9300t was working yesterday and briefly today, but it is now completely frozen in standby mode, so I can’t even access menus to verify what update I’m on or whetehr auto updates enabled. I’ve tried powering down and removing the aerial too, nut no luck….Any ideas?
Welcome to our Forum
Try powering it up without the aerial connected again that should give you access to the menu.
Thanks for the suggestion. Unfortunately removing the aerial and powering up didn’t make a difference. However, much pressing of the menu button on the control panel at power up has now changed the problem. It’s now frozen displaying PVR-9300T
Thans for that Martin. Will give it a go when I get home from work this eve,
- You must be logged in to reply to this topic.