- This topic has 6 replies, 4 voices, and was last updated 1 year, 10 months ago by
.
-
Posts
-
Good morning,
I have asked HUMAX support about this but had no reply.
Can anyone on the forum help, please?
I have had a Humax 2000T PVR since 2016 and, because it has recently developed a problem with the signal strength for some channels in the internal tuner, I have recently bought a Humax FVP5000T 1Tb PVR, (S/N:63 7110731 00297).
I still use the 2000T for some good strength channels as well as the 5000T. However, I now have found a problem with this set up.
For some signals BOTH my machines respond to EITHER handset which means that a signal sent to one machine can (does!) make unwanted changes to the other.
Is there any setting I can change so that each machine will only respond to its correct handset?
Any help or advice will be greatly appreciated.
CP
Covered in the FAQ’s.
https://myhumax.org/forum/topic/multi-code-function-fvp-remote
Good morning. The action suggested at the link does not work for me. The red light does not stay on on the remote control. I believe it may not be the original remote as the PVR is a refurbished model.
Any ideas please?
Thank you.
W
Wchumax – 2 hours ago »
Good morning. The action suggested at the link does not work for me. The red light does not stay on on the remote control. I believe it may not be the original remote as the PVR is a refurbished model.
You don’t make it clear which box you are changing. If it is the FVP-5000T then try changing the mode on the 2000T instead; procedure is just the same.
It’s a FVP 5000T. The other one is a HDR Fox T2. It has a replacement remote control too and the OK+0 reset does not work on that either.
Wchumax – 2 hours ago »
It’s a FVP 5000T. The other one is a HDR Fox T2. It has a replacement remote control too and the OK+0 reset does not work on that either.
Then you need to buy a remote control for one of the boxes that will allow the mode to be changed.
Thank you. I’ll do that.
- You must be logged in to reply to this topic.