- This topic has 9 replies, 3 voices, and was last updated 4 years, 10 months ago by
.
-
Posts
-
Hi,
I’ve got a humax hdr-1000s but only one of the receivers appears to be working.
I’ve swapped the input cables around and only 1 receiver is still working.
Any ideas on a fix?
Markovitz – 35 mins ago »
Hi,
I’ve got a humax hdr-1000s but only one of the receivers appears to be working.
I’ve swapped the input cables around and only 1 receiver is still working.
Any ideas on a fix?
I presume you mean tuners. The box is a receiver. Why do you think only one tuner is working.
When you swapped the inputs what do you get on the TV and what before the swap ?
Can you give an example of what you think should work and does not. ?
Sorry, tuners..
Tuner 1 has a good signal.
Tuner 2 has no signal.
Both tuners should have a signal as they are both connected to the lnb.
“Tuner 1 has a good signal.
Tuner 2 has no signal.”
If you swap the cables what do get?
What does it say at the bottom of the signal page?
Check the fitting of the F connector, it needs to make a good electrical circuit with no part of the braid or foil touching the inner wire. The braid or foil must be in contact with the F Connector.
If I swap the cables T1 still has good signal, T2 nothing.
It says connected with 1 cable.
Checked input cables as they both work on T1.
Markovitz – 1 min ago »
If I swap the cables T1 still has good signal, T2 nothing.
It says connected with 1 cable.
Checked input cables as they both work on T1.
Looking like you may need a new lnb, or tuner 2 has failed (very rare) unless you have had water in the cabling that has got into the box. .
Try this to check tuner 2 is working.
Enter 104 to go to Channel 4 and press the instant record button to start a recording.
Enter 949 to go to BBC2-HD and press the instant record button to start a second recording.
Check you have both recordings in the recordings list.
Exit recordings list.
Use channel up/down buttons to confirm you have 3rd viewing channels available,
I cannot record and watch something else at the same time.
I found an earlier post on the forum where it recommended a factory re-set.
I’ve just done that and now tuner 2 is working and has good signal.
Must be a software glitch.
LNB must be working fine.
Markovitz – 11 mins ago »
Try again..
Image too large. Need to reduce longest side to about 1200 pixels.
https://www.groovypost.com/howto/use-windows-10-photos-app-to-resize-images/
looks like bad news. Any sign of moisture ingress on tuner 2 in ?
With only one tuner you are restricted to recording two from the same transponder.
eg BBC1-HD and BBC2-HD should be recordable.
example.
102 BBC Two HD 10847 V
106 BBC One HD 10847 V
600 CBBC HD 10847 V
971 BBC Two HD Wales 10847 V
972 BBC One HD 10847 V
949 BBC Two HD 10847 V
979 BBC Two Wales 10847 V
978 BBC One NI HD 10847 V
Channels on each transponder
https://www.adrive.com/public/JAWF7Y/FoxsatStaticMK2_011.pdf
- You must be logged in to reply to this topic.