- This topic has 3 replies, 2 voices, and was last updated 7 years, 5 months ago by
.
-
Posts
-
Hi
Hoping for some advice. I have just purchased a Foxsat HDR. When I got it it started up fine. I decided to start afresh so did a factory reset from the menu.
The device is now stuck in the same loop. It enters boot then starts the wizard. I can get past past the post code check and starts to scam for channel but then ‘re boots and goes through the same! I hate to think I bought a dud any advice welcome!
1. Try a cold restart (turn off power 10 mins) and restart.
2. Power off for 10 mins and then open unit and disconnect hard-disk SATA and power connectors. If boots try and complete scan and then power down for another 10 min, reconnect Hard-disk and reboot. Format Hard-disk.
No such luck. It still does the same loop with the HDD unplugged.
It will go through the following settings.
1. User Settings
2. Freesat detection – signal on both LNB detected and no software found
3. Postcode – locates and says England HD
4. Search channels – nothing happens then reboots after about 10secs
When it starts it says u7.51 is there an firmware update I can do from USB?
Try flashing the latest custom firmware from here:
It contains the stock Humax firmware and some extra’s.
Reconnect the Hard-disk first.
From memory to flash:
1. Extract software to root on USB stick. Don’t change the name.
2. Put unit in standby for a few mins. Inset stick. Hold down button on unit and press power.
- You must be logged in to reply to this topic.