- This topic has 5 replies, 3 voices, and was last updated 8 years, 7 months ago by
.
-
Posts
-
Hello all, first time poster so apologies if this has been covered before, had my 4000t set up a week now and it’s been fine except it sometimes comes out of standby about 5/10 minutes after a timed recording has finished, at first I thought it might be my Sky remote that was switching it on. Is this a known thing with these units?
Welcome to the forum.
Check what version software you have. It should be 1.01.57 or the newest 1.02.13. I had this problem on an earlier version. For me it was responding to other remotes.
David.
Hello David, software version is 1.01.57, after a wee bit further messing around with the unit it’s definitely not that it’s responding to other remotes, I have noticed that it doesn’t boot up as often if I don’t have it tuned in to the channel that I’m recording, but otherwise between 5 and 15 minutes after a timed recording ends it boots up.
It may well be a fault then. I would look into getting it replaced.
David.
Hello Barry, it’s booting to on, blue led, not changing inputs or anything.
- You must be logged in to reply to this topic.