- This topic has 6 replies, 4 voices, and was last updated 8 years, 7 months ago by
.
-
Posts
-
WHICH CABLES TO USE TO CONNECT TO LOGIC TVL24HED13
Hi welcome to our forum. Can’t find any details of the TV. Can you photograph what sockets the TV has on it ?
HDMI input x 3,SCART x 1,SVGA x 1,USB 2.0 x 1,Component input x 1,Composite input x 1
So if the FVP-4000T has all its accessories:
Connect the supplied HDMI cable;
Optionally conect the RF cable if you also want to use the TVs tuner (which with a FVP-4000T there would be little use);
Connection to your router will depend on whether you want to use the internet features and if you want to use WiFi, ethernet cable, or some other connection between the FVP-4000T and your router. all t
Geoffwb – 14 hours ago »
CONNECTED 4000T TO TELEVISION LOGIC L24HED13.JUST SAYS “NO SIGNAL” CONNECTED BACK TO OLD FREEVIEW BOX AND THAT WORKS SO THE SIGNAL IS THERE?
Please would you provide more detail?
When you connect the FVP-4000T to the TV can you see the FVP-4000Ts menus OK?
Have you tuned the FVP-4000T and what happened?
Is the message “NO SIGNAL” coming from the TV? In other words is it the same message that you would get from the TV if you were watching through the TV’s tuner and then removed the aerial from the TV?
Hi,no,cannot see 4000Ts menus.
Have not tuned 4000T.
NO SIGNAL showing on TV screen.
Remove scart connection at tv end and tv works on its own without freeview box.
Remove rf connection at tv end and it continues working ok through freeview box.
Remove roof ariel connection at freeview box and tv shows”NO SIGNAL”
As you can see I am connected to the old Freeview box!
When you connect the FVP4000 to the TV using the HDMI lead did you use the Source button on the TV R/C to select that HDMI input?
- You must be logged in to reply to this topic.