- This topic has 9 replies, 4 voices, and was last updated 10 years ago by
.
-
Posts
-
Hi. My 9200T will not record when set up under ‘recording schedule’ say for tomorrow. Also, what is the ‘lock, enable/disable’ for?
springgranddad4 – 1 hour ago »
Hi. My 9200T will not record when set up under ‘recording schedule’ say for tomorrow. Also, what is the ‘lock, enable/disable’ for?
Are you still manual tuning as you were before?
Instructions are here: Manual Tuning Instructions
Also when placed in standby does the front panel display show ‘–:–‘?
Explaination is here: my 9200t shows –:– in standby
Hello Luke. Yes I am manual tuning, and have done so just today. The standby display shows
. When I set to record, there is a small picture of a clock top right, but when the time comes, nothing happens.springgranddad4 – 30 minutes ago »
Hello Luke. Yes I am manual tuning, and have done so just today. The standby display shows
. When I set to record, there is a small picture of a clock top right, but when the time comes, nothing happens.Apologies springgranddad4. I posted the wrong link earlier.
springgranddad4 – 2 hours ago »
Hello Luke. Yes I am manual tuning, and have done so just today. The standby display shows
. When I set to record, there is a small picture of a clock top right, but when the time comes, nothing happens.You have indicated 5 dashes, this is not correct. Do you mean ‘4 dashes’ —- at the left hand side of the display or do you mean ‘2 dashes colon 2 dashes’ –:– at the right hand side of the display? Look carefully.
Hello Luke. You forced me to put my glasses on! Your 2nd option here. To the right, the 4 dashes are each two smaller ones, with a flashing colon between them. I set up to record at 15.20 yesterday and it didn’t. After 15 minutes I selected the channel I wanted to record, pressed record on the remote and it recorded no problem. Checked it this morning. Again, what is the lock, enable/disable in recording schedule for?
springgranddad4 – 50 minutes ago »
Again, what is the lock, enable/disable in recording schedule for?
Parental control; you can mark recordings as locked and they can only be played (or unlocked) by someone who knows the PIN.
springgranddad4 – 5 hours ago »
Hello Luke. You forced me to put my glasses on! Your 2nd option here. To the right, the 4 dashes are each two smaller ones, with a flashing colon between them. I set up to record at 15.20 yesterday and it didn’t. After 15 minutes I selected the channel I wanted to record, pressed record on the remote and it recorded no problem. Checked it this morning. Again, what is the lock, enable/disable in recording schedule for?
So when your 9200 is ON you have the clock displaying normally but when in STANDBY the clock is replaced by –:–. If this is correct then you need to follow my clock repair instructions linked to by Luke in post #4. Use ordinary household meths as the cleaning agent. The reason your recordings are failing from STANDBY is simply because your 9200 doesn’t know what time it is when in STANDBY.
I give up. Much as I would like to have this machine operating properly, I can’t get it to record in STANDBY. OK, so it doesn’t know what time it is in STANDBY. Very reasonable diagnosis and no doubt right, but it doesn’t help. All I get from humaxfix/diagnostictools is Subscription Expired. Perhaps I could get it serviced. Where? I’m near Haywards Heath.
I can only suggest you re-read my post #8 immediately above your last and if your clock is displaying –:– in STANDBY where the clock digits should be then you can fix it yourself by following my clock repair instructions.
- You must be logged in to reply to this topic.