- This topic has 5 replies, 3 voices, and was last updated 11 years, 4 months ago by
.
-
Posts
-
Is a faulty tuner replacement or fix possible? Or should I just use the box with one tuner (with it’s obvious limitations)?
Tried a tune (manual) on each input with each cable. Got no signal on one. When I look at the manual tune section I don’t get a signal on one tuner.
mikeabanks – 13 minutes ago »
Tried a tune (manual) on each input with each cable. Got no signal on one. When I look at the manual tune section I don’t get a signal on one tuner.
Seems pretty definitive, No idea if a tuner module change is a diy prospect. Has any one swapped a tuner module on a Foxsat-hdr ?
Other than that only suggestion is give Humax customer support a ring.
grahamlthompson – 22 hours ago »
mikeabanks – 13 minutes ago »
Tried a tune (manual) on each input with each cable. Got no signal on one. When I look at the manual tune section I don’t get a signal on one tuner.
Seems pretty definitive, No idea if a tuner module change is a diy prospect. Has any one swapped a tuner module on a Foxsat-hdr ?
Other than that only suggestion is give Humax customer support a ring.
The tuner is on a separate small board, however you do need to remove the mother board to detach and refit it.
I removed one from a dead Foxsat that I bricked and sold it to someone who had killed the second tuner (water ingress). He refitted it and was back to normal.
I think Humax ask quite a bit for the part.
The second tuner has mysteriously started working again! Maybe it was connected to the misaligned dish (see my other thread). I was sure I had tested for both inputs. Thanks for the information – it may become useful in future
- You must be logged in to reply to this topic.