- This topic has 2 replies, 2 voices, and was last updated 12 years, 1 month ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
This weekend my 9200T had the clock problem for the 3rd time. The 2nd time was in June 2012. The cleaning technique seems to have fixed it again, but I was wondering if there’s anything I can do to stop it happening again so quickly. I used isopropyl alcohol to clean it with.
Perhaps it’s not worthy worrying about as the unit is getting quite old.
I added a little bit of extra help to the end of another thread, perhaps you could try that.
Quote:As an additional help, after cleaning the clock end of the board with cotton buds and a small brush it might be advantageous to hold the board clock end down and brush on more cleaning fluid to effectively swill down the cleaned area, shake off the excess and blow dry with a hair dryer. Obviously only lightly warm the board rather than toasting it.Thanks for the tip – I’ll try that if (when) it happens again.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.