- This topic has 9 replies, 3 voices, and was last updated 12 years, 4 months ago by
.
-
Posts
-
HI, Please excuse my late arrival. My Humax 9200 has just developed a clock problem I get 4 dashes —- in place of time. I have looked in various places to located a CLEANING procedure instuctions ,which I believe I need, But so far been unable to locate. Could someone please send link. Thank You.
doulton – 2 minutes ago »
My Humax 9200 has just developed a clock problem I get 4 dashes —- in place of time. I have looked in various places to located a CLEANING procedure instuctions ,which I believe I need,
The FAQ section is where you should be looking. The famous Biggles instructions are what you requires see http://myhumax.org/forum/topic/the-9200-problem
Thank you for your fast reply In have tried this link many times but my problem 4 dashes — I understand requires a link to CLEANING. The above link does not explain which components or where require this clean up. Thank You
doulton – 9 minutes ago »
The above link does not explain which components or where require this clean up.
Yes it does try reading from the third paragraph onwards.
doulton – 10 hours ago »
HI, Please excuse my late arrival. My Humax 9200 has just developed a clock problem I get 4 dashes —- in place of time. I have looked in various places to located a CLEANING procedure instuctions ,which I believe I need, But so far been unable to locate. Could someone please send link. Thank You.
Look carefully at your display when the 9200 is in STANDBY, do you really see four dashes —- as you describe or do you see four dashes with a colon in the middle –:–?
Hi, Again I thank you. I wrongly assumed that this article referred to the –:– situation Thank You.
doulton – 1 hour ago »
Hi, Again I thank you. I wrongly assumed that this article referred to the –:– situation Thank You.
My article does refer to the –:– situation, what does your display show?
Hi, Thank you. Yes my display shows —-
- You must be logged in to reply to this topic.