Setup problem

Forum › Forums › Freesat HD › HDR 1000, 1010, 1100S › Setup problem

Tagged: , ,

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • March 10, 2013 at 9:10 pm #14442
    Anonymous
    Inactive

    I originally set up my recorder on a single satellite input. I now wish to add a second to enable simultaneous recording and viewing, but cannot get back to a setup screen to do so. Any suggestions?

    March 10, 2013 at 9:42 pm #42790
    Anonymous
    Inactive

    Factory reset will start the installation wizard again.

    March 11, 2013 at 9:24 am #42791
    Anonymous
    Inactive

    Thanks gonzo, however, I can’t find from any of the accompanying paperwork, how to do a factory reset! Can you explain the process please?

    March 11, 2013 at 9:27 am #42792
    Barry
    Moderator

    I’ll welcome you to the Forum :-)

    and jump in here:

    Settings

    System Settings

    Factory default

    Default password is 0000 (4 zero’s if required)

    Make a note of your timers as they will be reset as well, recordings will be unaffected.

    March 14, 2013 at 12:03 pm #42793
    Anonymous
    Inactive

    Thanks Barry. I have no idea how I did not find the factory setup on the menus, I was convinced I had run through all of them! The whole thing now works fine.

    March 14, 2013 at 12:29 pm #42794
    Anonymous
    Inactive

    I don’t think you can see it when recording. I liked the Foxsat method of showing them greyed out.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.

The inner genius!