- This topic has 5 replies, 4 voices, and was last updated 13 years, 2 months ago by
.
-
Posts
-
Hi,
I have a Humax 9150T PVR which has given good service until developing a fault recently. On start up the unit just keeps on repeatedly launching the Application Loader software (running a4.39) When it reaches 100% a small “click” is heard from inside the unit before repeating the same routine over and over. Any ideas please?
Welcome to the Forum
Similar problem recently reported with a 9300 see this thread see if it helps:
Thanks for the reply Barry. Unfortunately, I cannot get as far as bringing up the menu screen. After the loader bar has reached 100% the screen goes blank and starts the cycle again. I notice also that the standby light is green throughout and will not respond to the remote. The fan also stops and starts, during the routine I have described. Thinking of perhaps a power supply problem?
Are you saying you can’t get into the menu even with the aerial removed?
welldigger99 – 12 hours ago »
After the loader bar has reached 100% the screen goes blank and starts the cycle again.
This problem has been reported a few times previously and I don’t think we have ever found a satisfactory solution; hope I can be proved wrong.
Yes, Biggles that is correct. There is no interaction with the remote at all -aerial in or out.
- You must be logged in to reply to this topic.