- This topic has 1 reply, 1 voice, and was last updated 10 years, 10 months ago by
.
-
Posts
-
If you are using more than one of the following receivers in the same location you can change the remote control coding so that the remote control commands do not conflict.
(This is only relevant to the Foxsat HD, HDR, HDCI 5000, HDR 1000/1010/1100S, HB1000/1100S, FVP-4000T/5000T, HD/HDR Fox T2 freeview HD products, incl the HDR 1800/2000T)
1. Switch on your TV set and the Humax product that you wish to change the remote code.
2. Make sure that the other Humax product that you do not wish to control is in Standby or powered OFF at the mains.
3. Point the remote control towards the remote control sensor of the target receiver.
4. Press and hold the 0 and OK buttons simultaneously for approx 5-10 seconds.
5. A message will appear on the TV screen:
“You can change the remote control mode.
Press a Numeric Key (<1> ~ <6>) to select the mode
Current mode: Mode 1.”
6. Press a NUMERIC button (from 1 to 6) to select a different mode.
7. A message confirming the change of Mode will appear on screen.
If your remote is of the multi function type, ie has tv and stb buttons then it can be programmed to control your TV.
See section at end of manual available via these links:
HDR 1000S:
https://uk.humaxdigital.com/wp-content/uploads/sites/6/2016/09/HDR-1000S_Manual.pdf
HDR 1100S:
https://uk.humaxdigital.com/wp-content/uploads/sites/6/2016/10/WM_HB-1100S_100GB_17-0412_s-1.pdf
- The topic ‘Remote Control – Multi Code / Function.’ is closed to new replies.