- This topic has 7 replies, 7 voices, and was last updated 4 years, 6 months ago by
.
-
Posts
-
When I press the guide button on 1000T it comes up No programme information does anyone have any suggestions.
Have you tried turning it OFF and ON again (unplugging the power not just putting it in standby) then leaving the guide to populate while you make yourself a nice calming cup of tea?
I have a Humax 4 Tune HMS-1000T and all of a sudden the IP EPG has completely stopped working. I have made sure the unit still has Wifi connection and even tried connecting it to my mobile 4G phone for the internet and done a Factory reset but still nothing. Does anyone have any ideas on what is going wrong. I am in Australia if that makes any difference and it has been working quite well for over 4 years.
Suggest contacting Humax Australia support:
I have experienced exactly the same problem with my faultless (till now) HUMAX 1000T loosing, and not refreshing the Guide details… I have tried reconnecting to the WIFI and attempting to refresh the EPG… But no success… Disconnecting the power made no difference to the situation. Still no Guide, therefore unable to record anything.
This has been a magic machine, so reliable, so straightforward to use… I will not be able to find an equivalent PVR should I have to find a replacement…
Exactly the same problem here too.
I did a factory reset and after a nights sleep it is working at the moment so fingers crossed,, it will be interesting to hear more feed back.
I had the same problem but it always fixed it self but it didn’t this time and no matter how many times i did a factory reset i still couldn’t get it to work.
I also had the problem with the WIFI on setup it would show your WiFi and i would put in the password and set it. But after it was all setup i still had no WIFI. So would go into network settings and discover there are two WIFI the second one is down list a bit and i set this and had my internet.
I did another factory reset and when i goto wifi i selected the second one and then this brought up the EPG and channel settings in one setup. If i hadn’t selected the second WiFi on setup it would have just setup the channel’s and not the EPG. I hope this will.
- You must be logged in to reply to this topic.