- This topic has 2 replies, 2 voices, and was last updated 14 years ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
The average signal strength on my HDR Fox T2 is 80% but over the past few days it has risen to 83%.
I know that too much signal strength can cause problems and wondered at what percentage this would occur?
No need to panic,
, minor variations like that ocurr all the time due largely to atmospheric conditions (water vapour attenuates rf signals). Even 100% will normally be fine provided the quality (the important parameter) remains high. If you were lucky enough to live close to a high power transmitter the effect of signal overloading will be very obvious. Simple to fix just stick a cheap attenuator to the aerial downlead.
Ok won’t panic!
Thanks for the info. Much appreciated.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.